Версия от 8.01.2020
https://github.com/pav1388/cxg-e60wt
*Скачать, распаковать, подключить программатор.
*Если прошиваете первый раз, то запустить сначала файл reset_opt.cmd
*Запустить файл write_flash.cmd
*Если возникли проблемы с калибровкой, можно сбросить eeprom, для чего запустить файл reset_eeprom.cmd
Удачи!
lymes/pav13

Version from 8.01.2020
https://github.com/pav1388/cxg-e60wt
*Download, unzip, connect the programmer.
*If flashing for the first time, then start the reset_opt.cmd file first
*Run the file write_flash.cmd
*If you have problems with calibration, you can reset eeprom, for which launch the file reset_eeprom.cmd
Good luck!
lymes/pav13